Belt Vulcanizing Press Machine

Belt vulcanizing press machine is applicable to the connection and joint of conveyor belt. Vulcanization of rubber belt is a process from raw rubber to mature rubber. In this process, temperature, pressure and fluidization time need to be provided. In this process, the frame and water pressure plate provide pressure, and the electric control box and heating plate provide temperature and control vulcanization time. The vulcanization temperature of ordinary rubber belt is 145 °, and the vulcanization pressure is less than 1.5 MPa. The vulcanization time is different according to different tapes.

The belt joint made by this machine is smooth, which can reduce the wear of the drum and prolong the service life of the rubber conveyor belt. The belt vulcanizer is mainly used to repair the loopholes of the belt and the vulcanization of the belt joint. The electric heating principle is mainly adopted, and the pressing plate is pressurized by hand pressure and water pressure to make the joints of the whole machine under uniform pressure.

Features

1. This machine has the advantages of small volume, half light weight, low energy consumption and fast temperature rise.

2. After heating, the whole board surface has considerable flexibility and is closer to the tape than the conventional machine.

3. Each point of the upper and lower heating plates of the machine is heated evenly, and the heating layer and heat clamping layer are Trinity, with simple structure and easy installation.

Installation steps

1. Place the form of single root off the machine.

2. First put the pressure device (water pressure plate) on the placed lower rack machine, and then put the lower electric heating plate on it. After the three are aligned, the lower electric heating plate shall be covered with plastic film (or talc powder).

3. Place the tape joint that has been processed, processed and filled with rubber on the lower hot plate. After aligning the center line, fix both sides of the tape with clamping plates and clamping mechanisms.

4. Lay plastic film (or spread talcum powder) on the position corresponding to the lower electric heating plate on the tape joint, and then place the upper electric heating plate and heat insulation plate on it in sequence.

5. Place the upper frame on the heat shield and align it with the lower frame.

6. Install the pre tightening bolts, washers and nuts in the long holes at both ends of the upper and lower frames, and tighten the nuts with a wrench. At this time, the main part of the belt vulcanizer is installed.

7. Connect the quick connector of the booster pump system with the water inlet of the pressure device, and plug the primary power wire into the socket of the electric heating control box accordingly. Plug one end of the secondary wire into the socket of the electric heating control box and the other end into the electric heating plate. Insert the corresponding of the thermal resistance wire into the socket of the electric heating control box, and the other end into the temperature measuring hole of the electric heating plate. At this time, the belt vulcanizing press machine installation is completed.