Double Gap Vulcanizing Press

Detailed description

1.This Double Gap Vulcanizing Press machine is mainly used for tire tread vulcanization molding in tire retreading industry and pressing molding of rubber products requiring high temperature and high pressure in other production processes. The pressing form is up pressing type.

2. The machine is equipped with high and low pressure oil pump, which is directly driven by the motor. The motor is started by the magnetic starter, and the built-in thermal relay is used as overload protection. When the motor is overloaded or encounters fault, it will automatically stop working.

3. Each plate of the machine is equipped with a hydraulic push-out / pull-in device.

4.The machine has the functions of automatic pressure supplement, automatic exhaust, vulcanization digital display timing, automatic mold opening and so on. It can realize the automatic completion of a working cycle from "mold pull in - mold closing rise - automatic exhaust - vulcanization timing - mold opening drop - product launch".

5.The machine is equipped with manual control device, which can open and lower the mold in case of power failure.

6. In order to ensure the lifting balance of the lower hot plate worktable, a set of synchronous gear mechanism is configured on the front lower side of the main engine.

Advantages

1.Stable structure, high precision

2.Energy saving and high efficiency

3.Easy operation, high degree of automation

4.Strong adaptability, customizable

5.Good environmental performance

6.Easy maintenance, low failure rate

7.Strong market competitiveness

8.Advanced technology, superior performance

Matters needing attention

1. All molds must be centered when they are put into the flat plate, and gloves shall be worn when sending and taking molds.

2. When sticking the test piece to the mold, open the mold and be careful to hit your hand to prevent landing.

3. Adjust the pressure gauge according to the die size and the specified unit pressure.

4. It is forbidden to overstock uneven plates in the plate.

5. When cutting the sample with vulcanized plate, the protective rubber plate must be padded.

6. In case of equipment failure, the power supply must be cut off before handling.

7. When taking the test piece from the die, pay attention to the smooth surface of the die cavity and die surface to prevent scratches.

8. It is strictly prohibited to take the mold or clean up sundries when the plate rises.

9. Do not use the curing press beyond the specified temperature.

10. When double gap vulcanizing press is not used, cut off the power supply, put down the pressure and close the oil valve.