Today I will share with you the characteristics of the upper and lower heating plates of the vulcanizer:
1. The upper and lower heating plates of the vulcanizing machine are small in volume, light in weight, reduced by half, low energy consumption, and rapid temperature rise. After heating, the entire board surface is quite flexible, and it is closer to the tape than the conventional machine.
Under the pressure of 1.5mpa, the parallel tightness is not more than 0.03mm, usually the conventional machine does not have this performance.
2. The heating of the upper and lower heating plates of the vulcanizer is evenly heated. After entering the heat preservation period for 10 minutes, the temperature difference of each point on the working surface is only ± 3 ℃ ～ 4 ℃, exceeding the international standard.
3. The time from normal temperature to vulcanization temperature (145 ℃) is not more than 25min, the power is half lower than the same industry in the national watch, and the energy saving effect is good.
4. Vulcanization bonding or repairing once molding, the bonding part is flat and smooth, and the fastness is no different from the original tape.
5. The upper and lower heating plates of the vulcanizing machine are trinity. The structure is simple and easy to install. The five advantages of the upper and lower heating plates of the vulcanizer are unmatched by other machines.
