Vulcanizing machine A vulcanizing machine for various rubber and plastic products, consisting of a thermostat, a lifting mechanism, a press assembly, a constant temperature controller and a timing alarm. It is divided into electric heating, steam heating and thermal oil heating in three forms. Next, let's take a look at the working principle of the vulcanization machine.
Vulcanizing machine working principle
Rubber belt vulcanization is a whole process from raw rubber to mature rubber, in this whole process, the rubber vulcanization machine must show working pressure, temperature, and control vulcanized rubber time. Vulcanizing machine meets this whole process, by the sound card frame and pressure plate to show the working pressure, electrical control cabinet and heating plate to show the temperature and control the rubber vulcanization time. The temperature of vulcanized rubber is 145 degrees, the working pressure of vulcanized rubber is not more than 1.5mpa, and the vulcanized rubber time varies from 30 to 60 minutes according to the different tape.
Vulcanizing machine performance
1, PLC, HMI control, manual and automatic control system can be completed. The automatic control system can complete the functions of mode locking, exhaust pipe, temperature control, vulcanized rubber timing, alarm, mold throwing and so on. The touch screen instantly displays the temperature of each heating zone of the heating board.
2. The hydraulic cylinder is made of ZG270-500 raw materials, and the plunger pump is made of chilled aluminum alloy pig iron with dense material, which is finely cast after casting; The sealing mode of the hydraulic cylinder is YX type sealing ring.
3, heating plate pan side selection of hydraulic press automatic iron, in the effect of four hydraulic cylinders heating plate on both sides of the pad block another victory or defeat; Both sides of the heating plate are provided with anti-pad overlap devices.
4, each heating area of the heating plate is set up a set of temperature adjustment valve, under the control of PLC, to ensure that the temperature of each heating area of the heating plate is uniform.
5, hydraulic system: the application of the world's famous brand of hydraulic system, under the control of PLC, can complete automatic: closing, exhaust, mold unloading.
6, mechanical equipment at the same stage of balanced organization: in the service platform is directly below the same shaft around the generator set, the shaft is set up on both sides of the rack to ensure that the service platform level lift.
7. Mode-locking guide equipment: mode-locking guide equipment is set up on both sides of the lower pad, and the guide seat is installed on the frame plate and the service platform. The guide seat produces and processes the slope, and the slope spacing can be adjusted according to the top wire.
8, the mold boost organization: when the mold is built under the service platform of the four cylinders action, the platform will be forced to pull off, to avoid the phenomenon of sticking pot can not open the mold.
